BEGIN:VCALENDAR
VERSION:2.0
PRODID:-//hacksw/handcal//NONSGML v1.0//EN
CALSCALE:GREGORIAN
BEGIN:VEVENT
DTEND;TZID=Europe/Zurich:20220118T140000
UID:ae2d3885d1a94d42173f8ed434d1e63f
DTSTAMP:1777300693
LOCATION:ONLINE VIA ZOOM
ORGANIZER:Alumni Community of the FUSION-EP Master Program
DESCRIPTION:In ITER and a fusion reactor, tritium (T) and deuterium (D) are used as fuels. Because of resource scarcity and radioactivity of T, special care is required and we will face various restrictions in using huge amounts of tritium (T) for DT burning. Required are simultaneous achievements of self-sufficiency of T fuel with T breeding, efficient D-T burning, and T safety. Detailed requirements to keep T economy are,

1. Power generation compatible with T breeding
2. Having enough margin in T breeding
3. Huge T through-put due to poor burning efficiency
4. Optimized control of DT fueling for efficient DT burning
5. Quantitative analysis of D and T in plasma and in materials
6. Unknown isotope effects between D and T in burning plasma and T recycling systems
7. Large in-vessel T inventory hard to remove

They are related to today’s talk (Retention and recycling of D/T fuels) And requirements to keep T safety are (1) Unavoidable permeation and leakage in T
handling systems, (2) Isotope separation and fuel refinement (Contamination by H is
concerned), (3) Easy transfer of contamination through HTO, DTO, and OBT (Organic Binding T) (4) Significantly large decontamination factor required (more than 10^-6 ) in T handling systems, and (5) T safety required under severe accidents. These are not discussed here but quite important to establish a fusion reactor as an energy source. Please refer a published book for ex. “Tritium as a fuel of fusion reactor, Springer 2017, DOI 10.1007/978-4-431-56460-7”. 
The requirements to keep T economy are directly correlated to fuel recycling at plasma facing surfaces, because T inventory in the plasma facing materials is the largest except fuel reservoirs. In addition, the fuel recycling is a critical issue for efficient D-T burning. Nevertheless, the fuel retention and recycling in a fusion reactor is not well estimated. In this talk described are after general introduction on tritium in nature and as a fuel of D-T fusion reactor and what are required for T use in a fusion reactor, “Fundamentals of interactions of hydrogen with plasma facing materials” and “Hydrogen retention in present tokamaks” in which fuel retention rates at steady state operation or inventory in PFM and their difference between low Z (Carbon) wall and high Z (Tungsten) wall are explained. Finally given are summary and perspective on research works of the retention and
recycling of D/T fuels.
URL;VALUE=URI:https://fusionep-talks.egyplasma.com/calender/event.php?variableName=ae2d3885d1a94d42173f8ed434d1e63f
SUMMARY:Retention and recycling of D/T fuels in a fusion reactor
DTSTART;TZID=Europe/Zurich:20220118T130000
END:VEVENT
END:VCALENDAR